Will this fit my existing sensor holes and fog cutouts?

The bumper Requires Surface Prep without pre-cut sensor ports. Before installation, reference your vehicle's OEM rear bumper to identify sensor locations and fog hole positions, then carefully mark and cut the FRP to match. Test-fit before final panel prep to ensure alignment with factory wiring and lighting assemblies.

What prep is needed before painting?

Sand the primer surface with appropriate grit to promote paint adhesion, then clean thoroughly to remove dust. Apply your chosen primer and paint system per manufacturer instructions. FRP accepts standard automotive finishes — no special sealers required.

Does this wide body design affect trailer hitch or rear-end clearance?

The bumper extends the rear quarter profile for visual width; confirm clearance with your specific hitch setup before installation. Measure your existing hitch receiver height and any tow hardware against the bumper's geometry to avoid contact during articulation or full compression.